دستورالعمل‌های جفت‌کردن برای افزاره‌های خاص

Even if you manage to source the manual for a device, it might not contain enough information to make pairing possible. Here are details for a few common devices.

دسته‌های پلی‌استیشن ۵

Holding the Create button, press the PS button until the light bar is blinking to make it visible and pair it like any other Bluetooth device.

دسته‌های پلی‌استیشن ۴

Using the PS and “Share” button combination to pair the joypad can also be used to make the joypad visible and pair it like any other Bluetooth device.

Those devices can also use “cable-pairing”. Plug the joypads in via USB with the Bluetooth Settings opened, and Bluetooth turned on. You will get asked whether to set those joypads up without needing to press the PS button. Unplug them and press the PS to use them over Bluetooth.

دسته‌های پلی‌استیشن ۳

Those devices use “cable-pairing”. Plug the joypads in via USB with the Bluetooth Settings opened, and Bluetooth turned on. After pressing the PS button, you will get asked whether to set those joypads up. Unplug them and PS button to use them over Bluetooth.

کنترل از راه دور BD پلی‌استیشن ۳

Hold the “Start” and “Enter” buttons at the same time for around 5 seconds. You can then select the remote in the devices list as usual.

کنترل‌های وی و وی‌یوی نینتندو

Use the red “Sync” button inside the battery compartment to start the pairing process. Other button combinations will not keep pairing information, so you would need to do it all over again in short order. Also note that some software like console emulators will want direct access to the remotes, and, in those cases, you should not set them up in the Bluetooth panel. Refer to the application’s manual for instructions.

ION iCade

Hold down the bottom 4 buttons and the top white button to start the pairing process. When the pairing instructions appear, make sure to use only the cardinal directions to input the code, followed by any of the 2 white buttons to the far right of the arcade stick to confirm.